Rev A Locked Architecture Details
Run AD5940 datasheet limits review only.
Do not modify schematic wiring.
Do not add components.
Do not change nets.
Review the AD5940 placeholder against datasheet/application-circuit requirements and identify what must be locked before PCB layout.
Check:
- Rail requirements:
- AVDD valid voltage range
- DVDD valid voltage range
- IOVDD / digital I/O rail requirement
- REG_1V8 role
- whether DVDD_AD5940 may remain tied to MCU_3V3: yes/no/uncertain
- whether separate 1.8 V rail placeholder is required: yes/no/uncertain
- SPI/logic compatibility:
- whether STM32L552 3.3 V SPI can directly connect to AD5940: yes/no/uncertain
- whether level shifting may be required: yes/no/uncertain
- BioZ/EIS pins:
- map placeholder nets to likely AD5940 pins/functions: AD5940_I_PLUS_PATH AD5940_I_MINUS_PATH AD5940_V_PLUS_PATH AD5940_V_MINUS_PATH AD5940_CURRENT_SENSE_P AD5940_CURRENT_SENSE_N AD5940_EXC_MON AD5940_AIN_MON
- Application-circuit blockers:
- required external references
- required RTIA/RLOAD/RCAL components
- required clock/crystal if any
- required decoupling not already represented
- required reset/interrupt/control pins
- Pre-layout decision: Choose one: A. Keep AD5940 as placeholder only B. Add separate 1.8 V LDO placeholder C. Add level-shifter placeholder only D. Split DVDD_AD5940 from MCU_3V3 E. Need human datasheet review before schematic changes
Report only:
- AD5940 rail blockers
- SPI/logic blockers
- missing application-circuit components
- recommended next schematic action
- whether current AD5940 section is safe for PCB layout: yes/no
Thought for 7 sec
I’ll run a read-only AD5940 datasheet-limits review against the current placeholder section, check rails, SPI logic, pin-role mapping, and application-circuit gaps, then report only the blockers and next action.
Worked for 1 min 10 sec
STOP
Sorry for the wait — almost done...
Refine this doc
Ask about this doc
EchoS Bank uses a premium electrode/phantom dock, not cheap screw terminals as the primary interface.
Front-panel live inputs:
E1, E2, E3, E4, E5, E6, E7
Dedicated reference:
CAL_COM / CAL_REF
Do not label CAL_COM as E8.
Preferred connector architecture:
Each live electrode should support:
E#_SIG
E#_GUARD
E#_SHIELD_AGND
CAL_COM should support:
CAL_COM / CAL_REF
CAL_COM_SHIELD_AGND
Primary connector target:
premium keyed medical/test-grade push-pull circular connector, LEMO/REDEL or equivalent.
Optional validation ports:
SMA/MMCX/u.FL coax footprints may be added later for phase-testing and bench validation.
Do not add connector components yet.
Do not modify calibration bank.
Do not add mux chips yet.
