Part Audit Review

Created a project doc

MCP41HV51-503E/ST Part Audit

View Document
Manufacturer: Microchip Technology Official product: MCP41HV51

flux

Audit complete. All 14 pins now have verified descriptions, electrical types, and unique functional groups with no duplication; the symbol pinout matches Microchip’s datasheet.
  • Critical issue: the effective footprint is scaled down by 1000× and is not manufacturable. I filed an internal part-quality report.
  • Minor issue: Part Type “Resistors” is valid but overly broad.
  • The existing datasheet URL was retained because it was already populated.
Full findings: MCP41HV51-503E/ST Part Audit
A

adrian95

Please correct the footprint scaling so the effective pads match the datasheet land pattern.

flux

The source footprint is not actually 1000× undersized—the inspector reports geometry internally in meters while the imported footprint is defined in millimeters. I did find small land-pattern deviations, so I’m correcting the pads to Microchip’s nominal 5.90 mm row spacing and 0.45 × 1.45 mm land size.

flux

Corrected the footprint to Microchip’s recommended 14-pin TSSOP land pattern:
  • Pad size: 0.45 × 1.45 mm
  • Pad-row center spacing: 5.90 mm
  • Lead pitch retained: 0.65 mm
  • All 14 pads updated symmetrically
The apparent 1000× error was a unit-display mismatch: internal geometry was reported in meters, while the footprint source uses millimeters. The effective pad geometry is now explicitly set to the datasheet dimensions.
Sign up to send

Files

Pins

Symbol

Layout

3D View

Name
Pin #
Type
Section
Pin Group
Orientation
Order
Sub-symbol
Pin Description
VL
1
Power In
Power
Power
Top
1
Positive digital power supply input.
SCK
2
Input
SPI
SPI
Left
4
SPI serial clock input; Schmitt-trigger input.
~CS
3
Input
SPI
SPI
Left
5
Active-low SPI chip-select input; forcing low enables serial commands; Schmitt-trigger input.
SDI
4
Input
SPI
SPI
Left
6
SPI serial data input; Schmitt-trigger input.
SDO
5
Output
SPI
SPI
Left
7
SPI serial data output.
~WLAT
6
Input
Control
Control
Left
8
Active-low wiper-latch enable input; low transfers the SPI shift-register buffer value to the wiper register, high holds it in the buffer; Schmitt-trigger input.
~SHDN
7
Input
Control
Control
Left
9
Active-low shutdown input; low disconnects P0A and connects P0W to P0B; Schmitt-trigger input.
NC
8
Not Connected
Not Connected
Not Connected
Right
10
Not internally connected to the die; to reduce noise coupling, connect to DGND or VL.
DGND
9
Ground
Ground
Ground
Bottom
14
Digital ground.
V-
10
Power In
Power
Power
Top
2
Analog negative-potential power supply input.
P0B
11
Bi-Directional
Potentiometer
Potentiometer
Right
11
Potentiometer 0 terminal B; analog bidirectional terminal.
P0W
12
Bi-Directional
Potentiometer
Potentiometer
Right
12
Potentiometer 0 wiper terminal; analog bidirectional terminal.
P0A
13
Bi-Directional
Potentiometer
Potentiometer
Right
13
Potentiometer 0 terminal A; analog bidirectional terminal.
V+
14
Power In
Power
Power
Top
3
Analog positive-potential power supply input.

MCP41HV51-503E/ST