Part Datasheet Review

flux

Assigned Terminal Order and Pin Orientation across all 115 terminals: power is Top / 1, ground is Bottom / 10, RF/control/GPIO are on the left, and SIM/UART/RFFE/NC are on the right. The component review checks came back with no open errors, warnings, or uncertain findings.
Open items:
  • The rendered schematic image was not visually useful due to zoom/positioning, but structured property verification and component review checks passed.
Suggested next steps:
  1. If desired, I can clean up the visible schematic symbol placement/spacing next.
  2. Publish/version the corrected part for library reuse.
adrian95

adrian95

Add Pin Group and Section metadata for all terminals using broad functional groups.

flux

I’ll assign broad Pin Group and matching Section values across all 115 terminals, keeping each pin in exactly one functional group per your convention, then verify a representative sample.

flux

Added broad Pin Group and matching Section metadata across all 115 terminals. Groups used: Power, Ground, RF, SIM, UART, RFFE, Control, GPIO, and No Connect.
Open items:
  • Flux showed autocomplete warnings for some broad labels, but the values were applied successfully and match your convention that Section = Pin Group.
Suggested next steps:
  1. Run the component review checks again.
  2. Publish/version the corrected part for reuse.
Review and publish
Run review checks
Publish corrected part
Check symbol readability
Update review file
Sign up to send

Files

Pins

Symbol

Layout

Preview

Name
Pin #
Type
Part Type
Pin Description
Pin Group
NC_1
1
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_2
2
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_3
3
Not Connected
Terminal
Reserved (No Connection)
No Connect
EJ_TRST
4
Input
Terminal
JTAG test reset; requires external 10kΩ pull-down
Control
PMU_AT_IN
5
Input
Terminal
Anti-tamper input; short to GND if not used
Control
PMU_WAKEUP
6
Input
Terminal
Wakeup active high; device wake-up input
Control
VDD_RF
7
Power Out
Terminal
MIPI RFFE IO supply output for antenna tuning
Power
VSIM
8
Power Out
Terminal
SIM LDO output
Power
VDD_AUX
9
Power Out
Terminal
SC2 LDO output
Power
NC_4
10
Not Connected
Terminal
Reserved (No Connection)
No Connect
SIMIO
11
Bi-Directional
Terminal
SIM data, 1.8V
SIM
NC_5
12
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_6
13
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_7
14
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_8
15
Not Connected
Terminal
Reserved (No Connection)
No Connect
VBAT_FEM_1
16
Power In
Terminal
Input from battery to FEM
Power
VBAT_FEM_2
17
Power In
Terminal
Input from battery to FEM
Power
VBAT_FEM_3
18
Power In
Terminal
Input from battery to FEM
Power

LBAD0XX1SC-005

LBAD0XX1SC-005 thumbnail