Review all available part information (MPN, packag...
Thought for 9 sec
I can do this, but there’s one conflict to resolve first: the part currently has more than 10 functional groups (
Power, SIM, USB, UART, Control, Status, Analog, Audio, I2C, SDIO, Wireless, Ethernet, RF, Reserved, Ground), while you requested Terminal Order 1–10 and “each group/section should have a different orientation” even though only four orientations exist (Top, Bottom, Left, Right).Proposed approach:
- Keep Power = Terminal Order 1, Orientation Top
- Keep Ground = Terminal Order 10, Orientation Bottom
- Compress related groups into the remaining orders, e.g.:
- 2 Control / Status
- 3 USB
- 4 SIM
- 5 UART / I2C
- 6 Audio / SDIO
- 7 Wireless
- 8 Ethernet
- 9 RF / Analog / Reserved
- Distribute non-power/ground orientations across Left and Right, alternating by group.
Confirm this grouping/order scheme and I’ll apply it.
Yes, apply the proposed grouping and order scheme.
Thought for 6 sec
I’ll apply the agreed Terminal Order and Orientation scheme across the pin groups, then spot-check representative pins.
Worked for 3 mins 15 sec
Applied the agreed Terminal Order / Orientation scheme and verified representative pins.
Open items:
- Non-power/ground groups were distributed across Left/Right per the accepted compression scheme.
- Power is Terminal Order 1 / Top.
- Ground is Terminal Order 10 / Bottom.
Suggested next steps:
- Review the regenerated symbol visually for pin placement balance.
- Normalize remaining
Pin Type: UnspecifiedGND pins if desired.
Arrange, normalize, review
Arrange symbol visually
Normalize GND types
Run symbol review
Fix part mismatch
