copilot

Mermaid
graph TD;
    A[Adafruit MPU-6050] -- SCL --> B(SCL_EXT)
    A -- VIN --> C(VIN)
    A -- SDA --> D(SDA)
    A -- GND --> E(GND)
    A -- node_3Vo --> F(3Vo)
    A -- SDA_EXT --> G(SDA_EXT)
    A -- AD0 --> H(AD0)
    A -- INT --> I(INT)
    A -- FSYNC_IN --> J(FSYNC_IN)
    A -- CLKN --> K(CLKN)

    subgraph External Connections
        B
        C
        D
        E
        F
        G
        H
        I
        J
        K
    end

style A fill:#f9f,stroke:#333,stroke-width:4px
style B,C,D,E,F,G,H,I,J,K fill:#cff,stroke:#333,stroke-width:2px

note right of A
    Manufacturer: Adafruit
    Part Number: [MPU-6050](https://www.flux.ai/search?type=components&q=MPU-6050)
end note

copilot

• Parts Needed:
  • LD1117V33 or similar 3.3V linear voltage regulator
  • A 10μF capacitor (Cin) for the input
  • A 10μF capacitor (Cout) for the output to ensure stability
• Connections:
  1. Connect your 5V supply to the Input pin of the LD1117V33.
  2. Connect a GND line to the Ground pin of the LD1117V33.
  3. Your regulated 3.3V output will be available at the Output pin of the LD1117V33.
  4. Place the input capacitor between the Input pin and the GND.
  5. Place the output capacitor between the Output pin and the GND.

• Parts Needed:
  • Resistor R1
  • Resistor R2

• Voltage Divider Formula: $V_{out} = V_{in} \times \frac{R2}{R1 + R2}$

preyes

copilot

• U1: LD1117V33 (3.3V Voltage Regulator)
• C1, C2: 10μF capacitors (input and output capacitors for the regulator)

1. Power Input Preparation:
   • If you haven't already, assume a 5V power source is available in your project and label it accordingly.
2. Voltage Regulator Integration:
   • Connect VIN to U1:IN. This is your 5V input to the voltage regulator.
   • Connect GND to U1:GND (pin 2). This grounds the regulator.
3. Capacitors for Stability:
   • Connect C1:1 to U1:IN and C1:2 to GND. This capacitor should be placed close to the input of the regulator.
   • Connect C2:1 to U1:OUT and C2:2 to GND. This capacitor should be placed close to the output of the regulator.
4. 3.3V Power Output:
   • U1:OUT will now provide the regulated 3.3V. You can connect this pin to any components in your circuit that require 3.3V, including the 3.3V input pins of your MPU-6050 module and other 3.3V logic components.

• Since the MPU-6050 operates at 3.3V, you will directly connect U1:OUT to the 3.3V power input of your MPU-6050 module. If it is designated as 3Vo in your list, then:
  • Connect U1:OUT to 3Vo.

• Ensure that all GND pins in your project, including MPU-6050's GND, are connected together to form a common ground.