PCB Board for GearWorx Helmet Sanitizer Vending Machine

ADXL345 iMEMS® Accelerometer, 3 Axis Sensor Evaluation Board The ADXL345 measures acceleration in three axes (X, Y, Z) and outputs digital data via either I²C or SPI interfaces. It is widely used in applications like tilt sensing, vibration monitoring, free-fall detection, and motion-based user interfaces. Its high resolution (up to 13-bit) allows it to detect very small changes in motion, making it suitable for both consumer electronics and industrial applications. Key Features 3-axis acceleration measurement (X, Y, Z) Selectable measurement ranges: ±2g, ±4g, ±8g, ±16g High resolution (13-bit) with up to 4 mg/LSB sensitivity Digital output interfaces: I²C and SPI Low power consumption: ideal for battery-powered devices Built-in motion detection functions: Tap and double-tap detection Free-fall detection Activity and inactivity monitoring Wide bandwidth range: supports various data rates for different applications Operating voltage: typically 2.0V to 3.6V Compact package: small LGA form factor suitable for space-constrained designs Common Applications Smartphones and tablets (screen rotation, motion sensing) Wearable devices and fitness trackers Gaming controllers Robotics and drones Vibration and shock monitoring systems #commonpartslibrary #developmentboard #evaluationboard #sensor

A board with a lora module (which can be programmed) and the ability to work autonomously from a battery and a solar panel #mppt #solar #lora #stm

Time-to-Digital converter plug-on module (shield) for Raspberry Pi B+. The board utilizes a TDC7200 (TI) with a time resolution of ~50ps. The Start/Stop inputs to the TDC can be configured with JP2 from either external signals or coming from the RPi's GPIO5 pin in case a timing signal is present at this pin from another plug-on board on the same RPi. Start and Stop signals can be configured from different signals (coming from the input connectors) or the same source (setting "common" on JP3) either supplied from the Start input connector or GPIO5. Read-out of the TDC chip is done through the RPi's SPI bus.

ESP32 8 Relay Board. Has onboard mains to 5V or can use the ESP VIN for the +5V. 8 onboard relays capable of switching about 5A without adding additional tin to the traces.

Teensy-LC delivers an impressive collection of capabilities to make modern electronic projects simpler. It features an ARM Cortex-M0+ processor at 48 MHz, 62K Flash, 8K RAM, 12 bit analog input & output, hardware Serial, SPI & I2C, USB, and a total of 27 I/O pins

This is a low cost logic analyzer probe for oscilloscope Rigol MSO5000 with fixded CMOS/TTL logic for 3.3/5.0V input levels with full bandwidth

Controller for vending machine. Use stm32f407, pressure sensor HX711, FRAM, TFT display connectivity.

2Cell Battery Charger & A9G Module

A 5V power supply for solderless bread board designed.

DIY BMS using ATTINY841-SSU this hardware has a higher balance current, fuse and TVS diode to help with voltage spikes. Most importantly, an external crystal to the micro controller (attiny841) which means the device is more reliable in low voltage situations

Adaptation of 28-PINS PROJECT by FEDEVEL ACADEMY to Flux (c) 2015 Designed by FEDEVEL Academy http://www.fedevel.com/academy. Based on Arduino: http://www.arduino.cc. Released under Creative Commons Attribution-ShareAlike 3.0 Unported.

Photography Timer based on ATMEGA8-16AU controller, OLED display and button controls.

HADES Flight Control System. Complete flight control system designed from scratch. The flight control system is primarily designed for fixed-wing, autonomous drones to enable them to perform tasks autonomously, such as take-off, landing, waypoint navigation, payload delivery, etc.

Module PSU