// Howdy 👋.
//
// This is where you can create powerful part automations like resistors that tell you when too much current is flowing through them
// You can also create your own flexible parts, like generics (https://docs.flux.ai/Introduction/generic-parts)
//
// If you are new to writing code in Flux make sure to check out our get started docs: https://docs.flux.ai/reference/introduction
//
// We also have a Flux Slack Community in case you need help: https://join.slack.com/t/fluxcommunity/shared_invite/zt-2hi664box-TNSNJ_~nUkNHkxeULXkSog
//
// To infinity and beyond 🚀
#include < DallasTemperature.h >
#include < OneWire.h >
OneWire ourWire(2);
DallasTemperature sensors(& ourWire);
void setup() {
// put your setup code here, to run once:
pinMode(2, INPUT);
sensors.begin();
Serial.begin(115200);
//Serial.println("Hello, ESP32-C3!");
}