Review all available part information (MPN, package, pin count, description, properties). If no datasheet URL is already set, search the web for the official datasheet and update the part's Datasheet property with the URL. Then cross-check the schematic symbol, footprint, and pin descriptions against the datasheet. Summarize key specs and flag any mismatches.
I’ll inspect the current part metadata/symbol/footprint, find the official datasheet if needed, then cross-check pins and package details against it and record the detailed review in a project document.
I found an official Analog Devices PDF and the part already has a Datasheet URL set, so I’m using the official PDF for the verification without changing that property. The main issue so far is metadata/package naming: the current Package or Case Code is TO, while the datasheet calls this 10‑TDFN‑EP, 3 × 3 mm, package code T1033+1C.
Datasheet URL already exists, so I did not change it; the document notes the better direct ADI PDF URL.
Mismatches flagged: Package or Case Code = TO, library subtype Logic / AND, and suspicious mount = Reverse.
Symbol pinout and pin descriptions match the datasheet; footprint looks broadly consistent but should be validated against ADI land pattern 90-0003 for production release.
Suggested next steps:
Correct the package metadata to T1033+1C / 10-TDFN-EP 3x3.
Normalize the Datasheet URL to the direct ADI PDF.
Fix the library classification metadata from logic to power-management/current-limiter.
Input pin; connect a low-ESR ceramic capacitor to GND. For hot plug-in applications, see datasheet application information.
UVLO
2
Input
Control
Control
Left
3
UVLO adjustment; connect resistive divider from IN to GND to set UVLO threshold.
OVLO
3
Input
Control
Control
Left
4
OVLO adjustment; connect resistive divider from IN to GND to set OVLO threshold.
CLMODE
4
Input
Control
Control
Left
5
Current-limit mode selector: GND = continuous, 150kΩ to GND = latch-off, open = autoretry.
EN
5
Input
Control
Control
Left
6
Active-high enable input; internally pulled up to 1.6V.
FLAG
6
Open Collector
Status
Status
Right
8
Open-drain fault indicator output; pulls low for overcurrent after blanking time, reverse current, invalid RSETI, or reverse polarity on OUT while IN is valid.
UVOV
7
Open Collector
Status
Status
Right
9
Open-drain UV/OV fault output; pulls low when input falls below UVLO falling threshold or rises above OVLO rising threshold.
SETI
8
Bi-Directional
Control
Control
Left
7
Overcurrent-limit adjustment pin and current-monitor output; connect resistor from SETI to GND. Do not connect more than 10pF to SETI.
GND
9
Ground
Ground
Ground
Bottom
10
Ground.
OUT
10
Power Out
Power
Power
Top
2
Output pin. For long output cable or inductive load, see datasheet application information.
EP
11
Ground
Ground
Ground
Bottom
11
Exposed pad; connect to a large GND plane with several thermal vias for best thermal performance.