ESP32-S3 Part Audit
Assign a Terminal Order from 1 to 10, starting with Power. Power should be Terminal Order 1, and Ground should be last, Terminal Order 10. For Orientation, set Power to "Top" and Ground to "Bottom." For the remaining sections/groups, you may decide the Terminal Order and Orientation yourself. For Orientation, distribute them between "Left" and "Right" — don't put everything on one side. Each group/section should have a different orientation.
Thought for 11 sec
I’ll assign one shared order per functional group from 1–10, with Power = 1/Top and Ground = 10/Bottom, then alternate the remaining groups between Left and Right and verify every pin follows its group.
Worked for 1 min 53 sec
Updated and verified all 57 terminals:
- 1 — Power: Top
- 2 — Enable/Reset: Left
- 3 — Clock: Right
- 4 — GPIO/Analog: Left
- 5 — USB/JTAG: Right
- 6 — Flash/PSRAM interface: Left
- 7 — RF: Right
- 10 — Ground: Bottom
Orders 8 and 9 remain unused because the part has eight functional groups. Pin metadata, mappings, descriptions, and sections were preserved.
Improve symbol and checks
Clean symbol rendering
Segment paste aperture
Run final checks
Export part data
