Part Datasheet Audit
can you group together pins by their functions?
for example for Power, 3v3, gnd_1 gnd_2 etc
NOTE: If you group them, can you not add the same pin if you already added them in a group? You should know which pin function is common for its function.
Thought for 10 sec
I’ll assign each of the 57 pins to exactly one broad functional group based on its primary datasheet function, keep Section equal to Pin Group, and verify there are no duplicates or omissions.
Worked for 16 mins 7 sec
The grouping pass took longer than expected; I’m checking the persisted terminal properties before deciding whether any focused cleanup is needed.
Worked for 7 mins 11 sec
Grouped all 57 pins into exclusive functional sections: Power, Ground, RF, Enable, GPIO, Low-Frequency Clock, Memory Interface, JTAG, UART, and No Connect. Each physical pin appears exactly once, with matching Section/Pin Group, ordered pins, consistent orientations, electrical types, and datasheet-based descriptions.
Fix metadata and verify
Fix metadata
Review symbol rendering
Run final audit
