The project currently has six terminals but no PCB pads or footprint geometry. I’m now validating the exact Nexperia package pinout and specifications from the official datasheet.
The Datasheet URL is already set to the official Nexperia PDF, so no property change is needed. I found major symbol/footprint-state issues and am updating the audit report with the verified details.
Audit complete. The official Nexperia datasheet URL was already set, so no property update was needed. Major issues: six independent symbol terminals instead of three electrical nodes, missing pin descriptions, and no pads/active footprint geometry; I filed an internal part-quality report.
Re-check the audit against the official Nexperia datasheet: pins 1–3 are Source, pin 4 is Gate, and the unnumbered mounting base is a single Drain; keep the footprint geometry if it matches the datasheet, but do not expose D1/D2 as separate drain terminals—map them to the same Drain, add the missing pin descriptions, and update the audit accordingly.