Pin Grouping by Function

Assign a Terminal Order from 1 to 10, starting with Power. Power should be Terminal Order 1, and Ground should be last, Terminal Order 10. For Orientation, set Power to "Top" and Ground to "Bottom." For the remaining sections/groups, you may decide the Terminal Order and Orientation yourself. For Orientation, distribute them between "Left" and "Right" — don't put everything on one side. Each group/section should have a different orientation.

Thought for 8 sec

flux

There are currently 6 groups, but only 4 orientation values (Top, Bottom, Left, Right), so every group cannot have a unique orientation.

Should I proceed with:

Power — order 1, Top
Logic Interface — order 2, Left
Power Control — order 3, Right
RS-485 Bus — order 4, Right
Not Internally Connected — order 5, Left
Ground — order 10, Bottom

Terminal Order would remain unique and sequential among pins inside each group.

adrian95

Use the proposed order and orientations, and keep terminal ordering sequential within each group.

Worked for 27 sec

flux

Applied the approved ordering and orientations:

Power: starts at 1 — Top
Logic Interface: starts at 2 — Left
Power Control: 3 — Right
RS-485 Bus: starts at 4 — Right
Not Internally Connected: starts at 5 — Left
Ground: starts at 10 — Bottom

Terminal ordering is sequential within each group.

Preview symbol layout

Check terminal definitions

Improve functional groups

Add pin descriptions

Files

Pins

Symbol

Layout

3D View

ADM2865EBRNZ