I’ve reconciled the independent audit with the project data. The 68-contact numbering is consistent, but the symbol metadata and locator-hole tolerance need attention; I’m recording the full evidence and mismatch list now.

Audit complete. The 68 contact pads and primary footprint geometry match the Molex documentation; the Datasheet URL was already populated, so it was not changed.

Key flags: missing Part Type/package metadata, all symbol pins lack descriptions and electrical types, MP1/MP2 are mechanical tabs rather than connector circuits, and the Ø2.60 mm locator holes are at Molex’s maximum allowed tolerance. Full results: Part Audit.