Have you ever wanted to wake up to one of the most energizing scents? Have you ever wanted that cup of energy in your hands before you even slide out of your covers? Well want no further! Introducing the Coffee Waker; The knight of your nightstand, a coffee maker alarm clock with one soul purpose, to quickly and scrumptiously wake you up. This is the Coffee Waker Main board. It contains an ESP32-S3, 16 bit Load Cell ADC, 16 bit MP3 DAC, 120V heater cartridge relay, and 12C wakeup light convector.

ESP32-C3 Espresso Smart Scale --------------------------------------------- Powered by TinyML so you never pull a sour shot again.

Have you ever wanted to wake up to one of the most energizing scents? Have you ever wanted that cup of energy in your hands before you even slide out of your covers? Well want no further! Introducing the Coffee Waker; The knight of your nightstand, a coffee maker alarm clock with one soul purpose, to quickly and scrumptiously wake you up. This is the Coffee Waker Main board. It contains an ESP32-S3, 16 bit Load Cell ADC, 16 bit MP3 DAC, 120V heater cartridge relay, and 12C wakeup light convector.

-----

The Onsemi NCP176 CMOS Low Dropout (LDO) Regulator is designed for superior transient response and low voltage operation, providing a maximum output current of 500 mA. It operates with an input voltage range from 1.4 V to 5.5 V and offers an output voltage range from 0.7 V to 3.6 V in 0.1 V steps. Characterized by a typical quiescent current of 60 µA and a low dropout voltage of 130 mV at 500 mA with a 2.5 V output, the NCP176 ensures high output voltage accuracy of ±0.8% for outputs above 1.8 V. The regulator is stable with small 1 µF ceramic capacitors and includes features such as over-current protection, built-in soft start to suppress inrush current, thermal shutdown protection at 165℃, and an optional output discharge function available in the NCP176A variant. Packaged in a compact XDFN6 1.2 mm x 1.2 mm x 0.4 mm, this LDO regulator is ideal for battery-powered equipment, portable communication devices, and cameras.

3D Camera Module is a scalable SPI enabled 4 camera array pinout for 3D photogrammetry reconstruction which uses I2C to connect between each module to expand camera capacity while keeping capture sequences in sync. It uses ATMega32U4 with its built in USB 2.0 for data transfer and camera array adjustments and capture as well as a micro SD card slot for local image storage. An interrupt logic pinout should be used on the SPI master module as capture command. Each module is powered via USB-C (5V) or barrel jack (12V regulated to 5V).