Text File Assistance
Worked for 2 mins 56 sec
Blocked: I cannot create a true internal Edge.Cuts routed slot with the available PCB edit tools in this session.
What I did:
- Removed the earlier pad-style NPTH slot, because you clarified it must not be a pad or drilled hole.
- Did not resize, move components, reroute, or modify copper.
Current DRC after cleanup:
- Airwires: 0
- Overlapping copper: 0
- Floating copper / invalid layer / missing footprint errors: 0
- Remaining: 3 pre-existing dangling-trace warnings.
Why blocked:
- The available line/shape tools only support Top/Bottom layers.
- The board-outline tool supports a single closed board outline, not a separate internal Edge.Cuts milling path.
- So I cannot safely add the requested internal routed slot as true Edge.Cuts geometry from here.
You’ll need to add this one slot manually in the PCB editor / manufacturing mechanical layer:
- Centerline: X = -8.5mm
- Start: (-8.5mm, -60mm)
- End: (-8.5mm, +60mm)
- Routed slot width: 2mm
- Non-plated milling / Edge.Cuts layer.
Export the current Gerbers without the slot, and clearly note the manual slot requirement for fabrication.
Thought for 7 sec
I’ll export the current Gerbers as-is, without the slot, and state the manual milling-slot requirement clearly for fabrication.
Worked for 1 min 21 sec
Exported the current Gerbers without the isolation slot: glecs-v4p1-motor-starter-controller-gerbers.zip.
Manual fabrication requirement:
- Add a non-plated routed/milled slot on Edge.Cuts, not a drill pad.
- Centerline: X = -8.5mm
- Start: (-8.5mm, -60mm)
- End: (-8.5mm, +60mm)
- Slot width: 2mm
- Length: 120mm, leaving 10mm solid board bridges at top and bottom.
Pre-export DRC gate was clean: airwires = 0, overlapping copper = 0, missing footprints = 0, invalid layer = 0.
Export assembly package
Create fab note
Check Gerber readiness
Run final HV review
Export all files
