Voltage Input Device Setup

maker-lab

maker-lab

Add a voltage device 1/2 on pin 25 as input

flux

I’m blocked from making project changes right now because execution credits are unavailable.
What I understand you want: add a “voltage device 1/2” signal/input connection on pin 25. In the current Arduino shield template, I’d need to inspect which connector/pin maps to project “pin 25,” then add or wire the voltage input device to that pin and verify the schematic.
Nothing has been changed in the project in this session. Remaining work:
  1. Confirm what “voltage device 1/2” means electrically — e.g. a voltage divider 1/2, a voltage sensor input, or a named external voltage source.
  2. Identify pin 25 in the existing Arduino shield schematic.
  3. Add the required input circuitry and connect it to pin 25.
  4. Verify power/ground, input voltage limits, and schematic review results.
Wire voltage divider
Find pin 25
Choose divider values
Run ERC/DRC
Sign up to send

No results...

Learn to Add a Component
Arduino thumbnail
Template for Arduino Uno R3 Shield. Include an official pinout so you will always know Arduino names, the alternative roles of pins, which one is SDA, or SCL, etc. On PCB you can find the 3D model of the Arduino Uno R3 itself along with the board outline on the silkscreen. #Arduino #Uno #Shield #Template #project-template #project

Properties

Properties describe core aspects of the project.

Pricing & Availability

Distributor

Qty 1

Arrow

$1.01–$2.49

Digi-Key

$2.93

LCSC

$2.10

Mouser

$2.93

Verical

$2.20–$3.48

Controls