Project Status and Action Items
Thought for 5 sec
I’ll remove the extra CN1 connector and move the Pico module up toward the top edge of the PCB, then verify the placement.
Worked for 1 min 27 sec
Done. I deleted
CN1 and moved U_MCU/Pico to the top of the board; it is now centered at about (10 mm, 88 mm) with its top edge just inside the board outline.Open item: the Pico was clamped at the board edge, so if you want more clearance from the top edge I can drop it slightly lower.
Thought for 5 sec
I’ll add a low-current front-panel power/enable switch rather than a high-current 12 V path switch, plus output/status LEDs with current-limiting resistors, then verify the schematic changes.
Worked for 1 min 54 sec
Added the power switch and output LEDs.
SW_PWR is a low-current front-panel switch that pulls Pico 3V3_EN to GND to turn logic off, and I added green indicators for BUS_12V and VOUT_19V5 with 4.7kΩ and 8.2kΩ series resistors.Open items:
- These are placed near the top/front-panel area but not routed yet.
- If you intended a true high-current input disconnect instead of a Pico enable switch, that needs a different switch/contactor architecture.
Route controls and verify
Use high-current switch
Route switch and LEDs
Add LED labels
Run design review
