// Howdy 👋.[ESP8266]
| --VCC --> 3.3V
| --GND --> Tierra
| --D2 --SDA --> [RC522]
| --D5 --SCK --> [RC522]
| --D7 --MOSI --> [RC522]
| --D6 --MISO --> [RC522]
| --D1 --TX --> [Sensor Huella]
| --D3 --RX --> [Sensor Huella]
| --D4 --Control --> [Relé]
| --D0 --DATA --> [Transmisor RF]
| --D8 --DATA --> [Receptor RF]
//
// This is where you can create powerful part automations like resistors that tell you when too much current is flowing through them
// You can also create your own flexible parts, like generics (https://docs.flux.ai/Introduction/generic-parts)
//
// If you are new to writing code in Flux make sure to check out our get started docs: https://docs.flux.ai/reference/introduction
//
// We also have a Flux Slack Community in case you need help: https://join.slack.com/t/fluxcommunity/shared_invite/zt-2ouyf80w6-7Wp81YlNEsuDFFdED9UQMA
//
// To infinity and beyond 🚀