Wearable Health Patch
Worked for 30 sec
Prepared the PCBWay DFM submission materials and regenerated the STEP model. I can’t submit to PCBWay directly from Flux, but these files are ready for you to upload to PCBWay’s rigid-flex/HDI quote channel for engineering feedback.
Project files:
Upload package:
Open items:
- Final assembly is still incomplete: DRC has unresolved airwires.
- Use these files for PCBWay engineering review only, not fabrication release.
- After PCBWay provides the approved stackup/via table, manually finish AD5940/ADS1292 fanout, clear airwires, rerun DRC, then regenerate final exports.
Start Auto-Layout
Thought for 13 sec
I’ll inspect the current PCB state, determine whether placement, routing, or both need work, then run the appropriate auto-layout operations and verify the applied result.
Thought for 22 sec
Blocked: your account currently has no available ACUs, so AI inspection and auto-layout operations are unavailable.
Current known project state:
- 6-layer rigid-flex working layout.
- AD5940 support placement previously reorganized.
- PCBWay HDI-oriented rules applied.
- Last verified state had 24 unresolved airwires.
No PCB changes were made in this session. Remaining work is to inspect the latest board state, determine whether placement and/or routing is needed, run auto-layout, apply the result, and verify DRC once ACUs are available.
Check ACU balance
List airwires
Check DRC/ERC
Manual placement review
