Diseño de PCB Regulador de Voltaje
auto-place the components with medium density spacing
Thought for 20 sec
flux
I’ll auto-place the components on the 140 × 100 mm board using medium spacing, grouped by power-supply function, with connectors and controls on edges and heat-generating parts separated.
Worked for 8 mins 7 sec
flux
Auto-placement completed, but I see one spacing issue and a few functional grouping warnings. I’m going to run one cleanup placement pass to pull parts fully inside the board and improve the regulator/control grouping.
Worked for 4 mins 41 sec
flux
Auto-placement is done on the 140 × 100 mm PCB with medium-density spacing.
What was completed:
- All 51 layout components were placed on the top layer.
- Components were grouped by function: AC/transformer section, rectifier/filter section, regulator/heat-sink section, voltmeters, connectors, and mounting holes.
- A cleanup placement pass fixed the remaining overlap and board-edge issues.
- Final placement result reported: no overlaps, no off-board parts, no critical placement issues.
What remains:
- A final review pass still needs to be run, but execution stopped because available credits ran out.
- The board is not routed yet; airwires are expected until routing is performed.
- Before routing, I recommend visually confirming the placement, especially transformer clearance, heat-sink direction, voltmeter readability, and connector access.
Run ERC/DRC
Route power paths
Check clearances
Add connector labels
Export placement report
