// Howdy 👋.
//
// This is where you can create powerful part automations like resistors that tell you when too much current is flowing through them
// You can also create your own flexible parts, like generics (https://docs.flux.ai/Introduction/generic-parts)
//
// If you are new to writing code in Flux make sure to check out our get started docs: https://docs.flux.ai/reference/introduction
//
// We also have a Flux Slack Community in case you need help: https://www.flux.ai/p/slack-community
//
// To infinity and beyond 🚀Objetivo
Diseña la PCB “Lilo’s Fuzz V1.1”.
Tamaño placa: 55 x 35 mm. 1 sola cara (copper bottom). Sin vías si es posible.
Fila superior de 9 pads de cabecera a paso 2.54 mm, orden (izq→dcha):
IN, V+, V+LED, GND1, GND2, GND3, FUZZ2, VOL3, OUT.
Reglas de diseño
- Capas: 1 (bottom copper). Sin vías. Si es imprescindible, como máx. 1–2 jumpers 0Ω.
- Pistas: V+ y GND = 1.0–1.2 mm; señales = 0.6–0.8 mm. Clearance ≥ 0.25 mm.
- Pads ovalados para cableado: taladro Ø1.2 mm, isla 3.0 × 2.4 mm.
- Contorno exacto: 55 x 35 mm (añade outline).
- Mantener IN y OUT físicamente separados (evitar acople).
- R4 // C_ab con pistas muy cortas entre colector Q2 y base Q1.