Attachment Review
Thought for 3 mins 39 sec
Thought for 40 sec
Reading "SKA60 mechanical drawing pin configuration bottom view dimensions pin spacing pins 1 2 3 4 5 6 7 8" in MEAN-WELL-SKA60-DATA-SHEET-4ba0cd0a-0105-408b-a92a-39b3b91888ca.pdf.
Thought for 7 sec
Thought for 18 sec — Updating component footprint
Found 1 results for Mean Well SKA60 mechanical drawing pin coordinates 8 pin 2x2 DC DC converter SKA60.
Read SKA60-SPEC.PDF.
Thought for 10 sec
Yes — I see it: the SKA60 uses a non-uniform 8-pin bottom-view pattern, not a simple 5.08mm grid. I’ll check the current U1 footprint against those coordinates and record/fix the footprint risk.
Worked for 5 mins 40 sec
Updated U1 to match the attached SKA60 mechanical spec: the footprint now uses the non-uniform bottom-view 8-pin pattern and 1.3mm drilled / 2.2mm pads for the 1.0mm pins.
Open items:
- The published custom part may still need the same footprint correction; I applied overrides in this project layout.
- DRC still reports airwires because routing has not been done yet.
Documented here: PCB Layout Notes.
Fix part, route, review
Fix custom part
Route the board
Run full DRC
Explain pin pattern
