ESP32 Smart City Controller
Thought for 7 sec
Claro — necesito que me indiques cuál capacitor y dónde debería ir.
Puedes responder con algo como:
- “C1 debe ir junto al conector del servo J3”
- “C3 debe ir cerca del pin 5V del ESP32”
- “El capacitor cerca de la esquina inferior derecha debe ir junto a U1”
Si puedes, selecciona el capacitor en Flux o dime su designador (C1, C2, C3, C4 o C5) y lo muevo a su lugar.
ya lo tengo seleccionado
Thought for 6 sec
Perfecto, revisaré el componente seleccionado y lo recolocaré donde corresponde según su función en el circuito.
Worked for 7 mins 33 sec
Listo. Moví C1 junto al conector del servo J3, manteniendo el resto de los componentes en sus posiciones. Verifiqué que quedó dentro de la placa y sin solapamientos.
Revisar, enrutar y verificar
Revisar colocación completa
Enrutar placa
Ejecutar DRC
Revisar polaridad
Refine this doc
Ask about this doc
User Manual Outline — ESP32 Smart City Controller
Safety Warnings
- Use only a regulated 5 V DC supply with correct polarity.
- Recommended supply rating is 3 A when the servo stall current is unknown.
- Do not connect external 5 V power and USB power simultaneously unless the exact DevKit revision is confirmed safe against backfeed.
- Disconnect power before wiring sensors, LEDs, or the servo.
- Servo motion can pinch or strike nearby objects; secure the mechanism before testing.
Connections
- J1: 5 V input.
- J2: HC-SR04 VCC/TRIG/ECHO/GND.
- J3: servo Gnd/5v/Data.
- J4: 3.3 V microphone.
- J5: 10 kΩ sensitivity potentiometer.
- J6–J11: LED signal and GND outputs.
Getting Started
- Inspect polarity and wiring.
- Program the ESP32 through onboard USB with J1 disconnected.
- Test without the servo.
- Apply regulated 5 V to J1.
- Connect the servo only after confirming stable 5 V and 3.3 V rails.
Operating Limits
- Indoor prototype use.
- GPIO and analog inputs must remain within 0–3.3 V.
- LED headers are outputs, not external power inputs.
Safety Warnings
Connections
Getting Started
Operating Limits
