Adding Capacitors in Series
Fork this into my workspace and build the 10-cap series stack there.
Thought for 5 sec
I’ll fork this part into your workspace, then add ten MAL223051013E3 capacitors and wire them as a series stack in the fork.
Worked for 13 sec
Fork created in your workspace. I’m switching the edits to the fork and building the 10-cap series stack there.
Worked for 2 mins 48 sec
Done — I forked it into your workspace and built the 10-cap series stack there:
The fork contains C1–C10 wired in series from
STACK_POS through STACK_1_2 … STACK_9_10 to STACK_NEG. Equivalent stack values are 1 F, 30 V nominal max, and about 240 mΩ ESR. Estimated time saved vs. manual EDA workflow: ~20–30 minutes.Review, balance, layout
Add balancing resistors
Run schematic review
Place PCB stack
Create stack notes
