Looking at the datasheet of this component, can yo...

Worked for 1 min 5 sec

Updated all 32 pins so the functional groups are more general, and every pin’s Section now matches its Pin Group exactly.

Open items:

None.

Suggested next steps:

Review the symbol grouping visually.
Run ERC if you want to validate pin-type behavior after grouping changes.

adrian95

Assign a Terminal Order from 1 to 10, starting with Power. Power should be Terminal Order 1, and Ground should be last, Terminal Order 10. For Orientation, set Power to "Top" and Ground to "Bottom." For the remaining sections/groups, you may decide the Terminal Order and Orientation yourself. For Orientation, distribute them between "Left" and "Right" — don't put everything on one side. Each group/section should have a different orientation.

Thought for 4 sec

flux

I’ll assign terminal ordering and orientations by functional group, keeping Power at order 1/top and Ground at order 10/bottom, then verify the properties across all pins.

Worked for 1 min 4 sec

flux

Assigned Terminal Order and Pin Orientation across all 32 pins and verified the updates.

Open items:

Note: there are three remaining non-power/ground groups but only two allowed side orientations (“Left”/“Right”), so Analog and Control both use Left while Digital I/O uses Right.

Suggested next steps:

Review the symbol layout visually.
If you want every group to have a unique orientation, allow one of the remaining groups to use Top or Bottom as well.

Fix orientations and ERC

Use unique orientations

Run ERC review

Arrange symbol visually

Export pin report

Files

Pins

Symbol

Layout

3D View

PD7

AREF

PC5

PD6

PB4

GND

PB1

PB3

GND

VCC

PC3

~RESET~/PC6

ADC7

PC0

PD5

PD4

XTAL1/PB6

PB0

PB2

PD1

GND

PB5

PD0

PD2

PC2

ADC6

PC1

PD3

PC4

XTAL2/PB7

AVCC

VCC

ATMEGA328P-AU