لا. إذا كنت في عرض PCB / Layout فلن تظهر أداة Wire الخاصة بالـ schematic.

في Flux يوجد فرق بينهما:

إذا كنت تحت PCB وتريد توصيل آخر airwires:

أما إذا كنت تريد أداة Wire نفسها، ارجع إلى تبويب Schematic.

the last few steps. Revert the layout locally around the B2 and B3 airwire endpoints (Trace ce13/cf92 and Trace 6e36/eb10) to a clean state, clear any temporary fragments, and position the view directly on the B2 gap so we can complete it."

💡

I’ll clean only the local B2/B3 endpoint fragments you named, verify the remaining DRC state, and give you the exact B2 location to zoom to since I can’t directly move your viewport from here.

I started the cleanup flow and identified the target as the local B2/B3 endpoint area: B2 around Trace ce13/cf92, and B3 around Trace 6e36/eb10.

I’m blocked now because there are no available ACUs, so I can’t run the layout-edit tools to delete those fragments or verify DRC. What remains: delete the local temporary fragments around those four trace endpoints, rerun DRC, then manually zoom to the B2 pad/gap area near component B2 at approximately X 2241.26 mm, Y -0.77 mm.