H1 Pin Header Connections
Thought for 45 sec
I can set the PCB board size to 28 mm x 21 mm without changing the outline shape or moving components. Do you want me to apply this change now?
Note: After resizing, based on knowledge base guidance, leave space for routing and vias and use airwires to visualize routing paths. If the tighter size crowds parts, we may need to adjust placement later.
I’m set on 28 mm x 21 mm even if routing is tight. Next, I want to review critical net placement.
Thought for 1 min 16 sec
I can set the PCB board size to 28 mm x 21 mm now.
After resizing, I’ll review critical nets next. I’ll pull placement/routing data for:
- TBUS_CAN_H/L
- TBUS_RS485_A/B
- TBUS_I2C_SCL/SDA
- T_BUS_1WIRE
- 3V3, 5V, GND
If there are any additional nets you consider critical, tell me so I include them.
Note: Leave space for routing and vias and use airwires to visualize routing paths. DRC runs continuously in the Review panel.
Specify critical nets
Ask for concrete placement tips
Request per-net guidance
Clarify routing constraints
Include ground/power strategy
Welcome 👋
Flux helps you build PCBs faster with an AI teammate!
Create your account to collaborate, stay updated, fork your own version, and get instant answers from our AI agent.