Sensor Replacement Request
Updating airwires and running DRC...
0:10
Started: Update airwires and run DRC.
Routing new nets using Auto-Layout...
0:07
Started: Route any new or changed nets using Auto-Layout if needed.
Thought
Work done
- Updated project description to “ESP32-CAM WiFi Camera with RCWL-0516 Microwave Motion Detection”
- Removed U2: HC-SR501 sensor
- Disconnected HC-SR501 nets (VCC, GND, Data)
- Added RCWL-0516 Module as U2 in schematic
- Connected RCWL-0516:
- VCC → +5V (Net 1)
- GND → GND
- OUT → motion signal (Net 8)
Tasks remaining
- Place the RCWL-0516 footprint on the PCB
- Update airwires and run DRC to verify connections
- Route new/changed nets using Auto-Layout
Success criteria review
- ✅ HC-SR501 removed from schematic & BOM
- ✅ RCWL-0516 added and wired (VCC, GND, OUT to correct nets)
- ❌ PCB layout update (footprint placement, routing, DRC) still pending
Recommended next step
Proceed with PCB-layout updates: place the RCWL-0516 footprint, refresh airwires, run DRC, then auto-route the changed nets.
Welcome 👋
Flux accelerates your PCB design with AI.
Create your account to start using this component and bring your ideas to life.