Voltage Level Translator Bidirectional 1 Circuit 8 Channel 60Mbps 20-TSSOP This device is an 8-bit non-inverting level translator which uses two separate configurable power-supply rails. The A port tracks the VCCA pin supply voltage. The VCCA pin accepts any supply voltage between 1.4V and 3.6V. The B port tracks the VCCB pin supply voltage. The VCCB pin accepts any supply voltage between 1.65V and 5.5V. Two input supply pins allows for low Voltage bidirectional translation between any of the 1.5V, 1.8V, 2.5V, 3.3V, and 5V voltage nodes. When the output-enable (OE) input is low, all outputs are placed in the high-impedance (Hi-Z) state. To put the device in the Hi-Z state during power-up or power-down periods, tie OE to GND through a pulldown resistor. The current-sourcing capability of the driver determines the minimum value of the resistor. • No direction-control signal needed • Maximum data rates: – 110Mbps (push pull) – 1.2Mbps (open drain) • 1.4V to 3.6V on A port and 1.65V to 5.5V on B port (VCCA ≤ VCCB) • No power-supply sequencing required – either VCCA or VCCB can be ramped first • Latch-up performance exceeds 100mA per JESD 78, class II • ESD protection exceeds JESD 22 (A port): – 2000 V Human Body Model (A114-B) – 150 V Machine Model (A115-A) – 1000 V Charged-Device Model (C101) • IEC 61000-4-2 ESD (B-port): – ± 8kV Contact Discharge – ± 6kV Air Discharge #commonpartslibrary #integratedcircuit #logic #translator #levelshifter

Zener Diode 15V 500mW ±6% Surface Mount SOD-123 #commonpartslibrary #diode #zener

The NE555 devices are precision timing circuits capable of producing accurate time delays or oscillation. In time-delay or monostable operating modes, the timed interval is controlled by a single external resistor and capacitor network. In the astable mode of operation, the frequency and duty cycle are controlled independently with two external resistors and a single external capacitor. Each timer has a trigger level equal to approximately one-third of the supply voltage and a threshold level equal to approximately two-thirds of the supply voltage. These levels can be altered by use of the control voltage pin (CONT). When the trigger input (TRIG) is less than the trigger level, the flip-flop is set and the output goes high. If TRIG is greater than the trigger level and the threshold input (THRES) is greater than the threshold level, the flip-flop is reset and the output is low. The reset input (RESET) overrides all other inputs and is used to initiate a new timing cycle. If RESET is low, the flip-flop is reset and the output is low. Whenever the output is low, a lowimpedance path is provided between the discharge pin (DISCH) and the ground pin (GND). Tie all unused inputs to an appropriate logic level to prevent false triggering. The output circuit is capable of sinking or sourcing current up to 200mA. Operation is specified for supplies of 5V to 15V. With a 5V supply, output levels are compatible with TTL inputs. Features - Timing from microseconds to hours - Astable or monostable operation - Adjustable duty cycle - TTL-compatible output can sink or source up to 200mA - On products compliant to MIL-PRF-38535, all parameters are tested unless otherwise noted. Applications - Pulse-shaping circuits - Missing-pulse detectors - Pulse-width modulators - Pulse-position modulators - Sequential timers - Pulse generators -F requency dividers - Industrial controls

2.7 - 15V 0.7 - 5A Current Limit Switch with Over-Voltage Clamp and Reverse Blocking #ultralibrarian

Linear Voltage Regulator IC Positive 0V to 15V Programmable Output 500mA 12-MSOP #CommonPartsLibrary #IntegratedCircuit #PowerManagement #LinearRegulator #VoltageRegulator

15V Clamp 5A (8/20µs) Ipp Tvs Diode Surface Mount SLP2510P8 #commonpartslibrary #tvs #circuitprotection

Linear Voltage Regulator IC Positive 15V Fixed 1 Output 1.5A TO-220-3

Isolated Module DC DC Converter 2 Output 15V -15V 500mA, 500mA 9V - 36V Input #commonpartslibrary #powersupply #dcdc #converter

Zener Diode 15V 5 W ±5% Through Hole Axial #CommonPartsLibrary #Zener #Diodes #SingleZenerDiodes

15V (Typ) Clamp 30A (8/20µs) Ipp Tvs Diode Surface Mount SOD-323 #CommonPartsLibrary #Diode #TVS

Infrared (IR) Emitter 860nm 1.5V 100mA 63mW/sr @ 100mA 40° Radial #Commonpartslibrary #optoelectronic #LED #infrared

Isolated Module DC DC Converter 2 Output 15V -15V 200mA, 200mA 9V - 36V Input #commonpartslibrary #powersupply #dcdc #converter