FRAM, or Ferroelectric Ram, is the coolest new data storage method that all the fashion magazines are talking about. Oh wait, no that's quilted handbags. But FRAM is pretty damn cool too! It's similar to Dynamic random-access memory, only with a ferroelectric layer instead of a dielectric layer. This gives it stable handling (the bytes you write are non-volatile) with dynamic responsiveness (you can write them very fast!)

Takes two 14VDC+ power supplies, regulates th

Welcome to your new project. Imagine what you can build here.

Adafruit Product

Adafruit Product

This is supposed to be the SGP30 break out board but without the two extra ports.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Memory IC Development Tools microSD Transflash Breakout #commonpartslibrary #integratedcircuit

GPS Development Tools SparkFun GNSS-RTK Dead Reckoning Breakout - ZED-F9K (Qwiic) #commonpartslibrary #module #gnss #gps

MicroSD card breakout board+ | Adafruit Industries 254 #commonpartslibrary #microsdcard #breakout #prototyping #breakoutboard

XIAO nRF52840 Breakout with Centered Accelerometer, Precision Mounting Holes, and Additional Battery Connector

SIM800L Quad-band Network Mini GPRS GSM Breakout Module. #componentpartslibrary #gprs #gsm

This breakout board will solve all your power-monitoring problems. Instead of struggling with two multimeters, you can just use the handy INA219B chip on this breakout to both measure both the high side voltage and DC current draw over I2C with 1% precision. #Sublayout #CurrentSensor

NXP JN5164/JN5169 breakout module, SMD #RF #ZigBee #commonpartslibrary

NXP JN5164/JN5169 breakout module, SMD #RF #ZigBee #commonpartslibrary

ALPS RS60N1219A04 Slider Potentiometer Breakout & Mounting Adapter PCB

ILI9341 controller, SPI TFT LCD Display, 9-pin breakout PCB, 4-pin SD card interface, 5V/3.3V driver display *CR2013*MI2120*

The TPL5110 Power Timer is a stand-alone breakout that will turn any electronics into low-power electronics! It will take care of turning your project on/off using a built in timer that can vary from once-every 100ms up to once every two hours. Basically, the TPL will turn on periodically, adjustable by potentiometer or resistor, and turn on your project's power. It will then wait until a signal is received from the project to tell the TPL that it can safely turn off the power. If the TPL does not receive a signal by the set time-out, it will reset the device like a watchdog timer. #Sublayout #Module #PowerTimer #TPL5110