TI Part Audit
Thought for 5 sec
I’ll audit the part metadata, source the official TI datasheet if needed, update the Datasheet property, then cross-check symbol pins and footprint geometry against the manufacturer documentation.
Worked for 4 mins 27 sec
The datasheet is already present and correct. I found several metadata and footprint issues, so I’m doing a final read-back to confirm the current project state before summarizing.
Thought for 20 sec
Audit complete. The existing Datasheet property already points to the correct official TI datasheet, so it was left unchanged.
- Key specs: 2.5–5.5 V input, adjustable 0.6 V–VIN output, 2 A synchronous buck, forced PWM, 2.4 MHz typical, 23 µA typical quiescent current, 6-pin DRL/SOT-563 package.
- Symbol: All six pin numbers and names match the datasheet, but electrical types and pin descriptions are missing.
- Metadata: “Part Type” is incorrectly classified as Linear Regulator; package is underspecified as SOT instead of DRL0006A/SOT-563.
- Footprint: Pin mapping and 0.50 mm pitch are correct, but the land dimensions and row spacing differ substantially from TI’s recommended pattern—approximately 0.475 × 0.30 mm and 2.151 mm outside span versus 0.67 × 0.30 mm and 1.48 mm.
- I filed an internal part-quality report for the footprint discrepancy. No footprint or symbol changes were made.
Fix metadata and footprint
Correct footprint only
Improve symbol metadata
Fix part classification
Recheck after fixes
