Part Audit

flux

I’ll audit the part metadata, locate the official ST datasheet if needed, compare symbol/footprint/pins against it, update the Datasheet property, and document any discrepancies.

flux

The project is a three-terminal part definition rather than a normal placed component. I’m now checking its footprint and project-level metadata before comparing it to the manufacturer drawing.

flux

I’m checking the package geometry, pad numbering, and hidden project properties in parallel.

flux

The footprint currently identifies itself as STPS10L40CSF/PSMC (TO-277A) while the project MPN is STPS10M60SF; I’m verifying whether that is a harmless family reuse or a real mismatch.
Created a project doc

Part Audit

View Document
Part Audit Identity and existing properties Datasheet key specifications
  • Device: single low-drop power Schottky rectifier
  • Package: PSMC (TO-277A), 90 mg, tape-and-reel base quantity 6000
  • Marking: PS10M60
  • Repetitive peak reverse voltage, VRRM: 60 V
  • Average forward current, IF(AV): 10 A at Tc = 145 °C, 50% square-wave duty
  • Non-repetitive surge current, IFSM: 230 A, 10 ms sinusoidal pulse
  • Maximum junction temperature: 175 °C
  • Maximum forward voltage: 0.56 V at 5 A and 25 °C; 0.65 V at 10 A and 25 °C
  • Maximum reverse leakage at VRRM: 50 µA at 25 °C; 25 mA at 125 °C (8 mA typical)
  • Features: low profile (1.1 mm typical), wettable flanks, avalanche capability, ECOPACK2 compliance
Pin and symbol cross-check

flux

Audit complete. The official ST datasheet URL was already set, and the 3-pin mapping and TO-277A land pattern match; issues are missing package/pin metadata, an ambiguous description, and a footprint filename referencing STPS10L40CSF.
Full specs and findings: Part Audit.
Clean up part metadata
Rename footprint asset
Review 3D alignment
Sign up to send

Files

Pins

Symbol

Layout

3D View

Name
Pin #
Type
Part Type
Terminal Order
A
1
Unspecified
Terminal
A
2
Unspecified
Terminal
K
3
Unspecified
Terminal

STPS10M60SF