Murata Footprint Keepout

A

adrian95

Fix this issue: Official Murata land pattern matches the 7 pads and their dimensions/coordinates, but the footprint does not encode the datasheet isolation-barrier/under-module placement keepout or primary-side copper guidance.

flux

I’ll update the footprint with datasheet-derived copper/placement keepouts beneath the module, explicitly preserving the primary-to-secondary isolation barrier and primary-side copper restrictions, then verify the geometry against the official Murata drawing. This requires Agent mode to research the exact boundaries and edit the footprint.
A

adrian95

try again

flux

I’ll inspect the footprint, verify Murata’s exact under-module isolation and copper restrictions, then encode and validate the required keepouts.

flux

Updated and verified the footprint:
  • Added a 4 mm central isolation keepout on Top and Bottom layers.
  • Added dashed isolation boundaries at X = ±2 mm.
  • Added the 35.5 × 22.4 mm no-parts-under-module boundary.
  • Added primary-side “GND copper only” and placement warning labels.
  • Confirmed all seven original pads and coordinates remain unchanged.
Sign up to send

Files

Pins

Symbol

Layout

3D View

VC
Pin Number
4
DEN
Pin Number
2
T2P
Pin Number
3
+VIN
Pin Number
1
Name
Pin #
Type
Section
Pin Group
Orientation
Order
Sub-symbol
+VIN
1
Unspecified
DEN
2
Unspecified
T2P
3
Unspecified
VC
4
Unspecified
-VIN
5
Unspecified
-VOUT
6
Unspecified
+VOUT
7
Unspecified

MYBSP0055AABFT