Terminal Audit Complete

Perform an exhaustive direct read of all 289 terminal components in the current part project, paging as needed. Audit and FIX any issue so: exactly 289 remain; every terminal has nonblank Pin Group, Section equal to Pin Group, valid Orientation; no Sub-symbol Designator Suffix was created; Terminal Order is integer, unique and exactly 1..N within each group; all VSS_* and DCDC_GND_* are Ground/Bottom; no power or ground terminal is in any GPIO group; all power groups and DCDC/PMU are Top; all other terminals match the broad groups already established. Preserve names, Pin Numbers, Symbol Pin Positions and all unrelated properties. After fixes, re-read all 289 and report group counts and validation results.

Thought for 7 sec

flux

I’ll page through all 289 terminals, audit every required field and grouping rule, apply only targeted property fixes, then re-read the full set and validate counts, ordering, orientations, and preservation constraints.

Worked for 2 mins 30 sec

flux

The exhaustive audit found the project already compliant, so no writes were made. I’m now independently re-reading the terminal set to confirm the final inventory and constraints before closing.

Thought for 1 min

flux

Exhaustive paged audit and final re-read completed for all 289 terminals. No fixes were required; every validation passed, including group/section equality, valid orientation, blank suffixes, consecutive unique per-group ordering, and power/ground rules. Protected properties remained unchanged.

Group counts: GPIO EMC B1 42; Ground 37; GPIO AD 36; GPIO EMC B2 21; DCDC/PMU 18; GPIO DISP B2 16; GPIO LPSR 16; GPIO DISP B1 12; GPIO SD B2 12; Power 3V3 12; GPIO SNVS 10; Core/1V0 Power 9; SNVS/LPSR Power 8; Clocks 6; GPIO SD B1 6; MIPI CSI 6; MIPI DSI 6; USB 6; Power 1V8 4; Reset Boot Control 4; Analog/Reference 2. Total: 289.

Review and document

Check symbol rendering

Export pin table

Audit datasheet mapping

Files

Pins

Symbol

Layout

3D View

MIMXRT1173CVM8A