Part Datasheet Review
Worked for 56 sec
Assigned
Terminal Order and Pin Orientation across all 115 terminals: power is Top / 1, ground is Bottom / 10, RF/control/GPIO are on the left, and SIM/UART/RFFE/NC are on the right. The component review checks came back with no open errors, warnings, or uncertain findings.Open items:
- The rendered schematic image was not visually useful due to zoom/positioning, but structured property verification and component review checks passed.
Suggested next steps:
- If desired, I can clean up the visible schematic symbol placement/spacing next.
- Publish/version the corrected part for library reuse.
Add Pin Group and Section metadata for all terminals using broad functional groups.
Thought for 5 sec
I’ll assign broad
Pin Group and matching Section values across all 115 terminals, keeping each pin in exactly one functional group per your convention, then verify a representative sample.Worked for 3 mins 53 sec
Added broad
Pin Group and matching Section metadata across all 115 terminals. Groups used: Power, Ground, RF, SIM, UART, RFFE, Control, GPIO, and No Connect.Open items:
- Flux showed autocomplete warnings for some broad labels, but the values were applied successfully and match your convention that
Section = Pin Group.
Suggested next steps:
- Run the component review checks again.
- Publish/version the corrected part for reuse.
Review and publish
Run review checks
Publish corrected part
Check symbol readability
Update review file
Name
Pin #
Type
Part Type
Pin Description
Pin Group
NC_1
1
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_2
2
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_3
3
Not Connected
Terminal
Reserved (No Connection)
No Connect
EJ_TRST
4
Input
Terminal
JTAG test reset; requires external 10kΩ pull-down
Control
PMU_AT_IN
5
Input
Terminal
Anti-tamper input; short to GND if not used
Control
PMU_WAKEUP
6
Input
Terminal
Wakeup active high; device wake-up input
Control
VDD_RF
7
Power Out
Terminal
MIPI RFFE IO supply output for antenna tuning
Power
VSIM
8
Power Out
Terminal
SIM LDO output
Power
VDD_AUX
9
Power Out
Terminal
SC2 LDO output
Power
NC_4
10
Not Connected
Terminal
Reserved (No Connection)
No Connect
SIMIO
11
Bi-Directional
Terminal
SIM data, 1.8V
SIM
NC_5
12
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_6
13
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_7
14
Not Connected
Terminal
Reserved (No Connection)
No Connect
NC_8
15
Not Connected
Terminal
Reserved (No Connection)
No Connect
VBAT_FEM_1
16
Power In
Terminal
Input from battery to FEM
Power
VBAT_FEM_2
17
Power In
Terminal
Input from battery to FEM
Power
VBAT_FEM_3
18
Power In
Terminal
Input from battery to FEM
Power
LBAD0XX1SC-005
