I’ll audit the part metadata, locate and attach the official datasheet if needed, then verify the symbol, footprint, and pin descriptions against the manufacturer documentation. I’ll report key specifications and any concrete mismatches.

The official GlobTek datasheet is already attached, so no URL update is needed. I found the part metadata and footprint; I’m now checking the six electrical terminals, mounting hole, and mechanical dimensions against the current manufacturer drawing.

Audit complete: the MPN (GlobTek JACK-L-PC-10A-RA(R)), description, six physical terminals, through-hole right-angle package, and existing official GlobTek datasheet are consistent; key ratings are 5.5 mm OD / 2.5 mm ID, 10 A continuous, 24 VDC manufacturer rating (distributors list 50 VDC), and −25°C to +85°C.

Major mismatches: the datasheet specifies four 2.00 × 0.80 mm slots, one 3.00 × 0.80 mm slot, and round holes of Ø1.4 mm and Ø1.6 mm, while the footprint substitutes oversized circular drills (2.154 mm, 3.105 mm, and 1.7 mm); additionally, the symbol exposes six undefined independent pins with no descriptions, although the connector has only two electrical contacts and the remaining solder features must be mapped as duplicated/contact or mechanical terminals rather than unrelated signals.

The footprint should be corrected before fabrication, and the symbol needs authoritative contact mapping for terminals 1–6; the current part should not be considered manufacturing-ready.