Verification note: values below were extracted from the manufacturer PDF using OCR. The datasheet service did not return resolvable inline citation IDs, so page/table references are included instead.
Audit complete. The six electrical pins, I²C mapping, package body, and solder lands match the Honeywell datasheet, but the Ø0.45 mm gage-reference hole is incorrectly implemented as an electrical plated pad; pin types/descriptions and package metadata are also missing, and the part description incorrectly calls it a force-sensing resistor. A datasheet URL was already present, so it was left unchanged.
I’ll correct the part metadata and terminal semantics, then convert MH1 to a non-plated, non-electrical Ø0.45 mm mechanical hole and verify the symbol and footprint afterward.
Metadata and terminal definitions are corrected, and MH1 is now a Ø0.45 mm HOLE with its annular copper removed. I’m performing the final readback now.