Part Datasheet Review and Verification

flux

Completed the part review and created a detailed report: em8900-v001-df10bplus-part-datasheet-review.
Open items:
  • Official datasheet found: https://www.emmicroelectronic.com/sites/default/files/products/files/8900-ds.pdf
  • Datasheet URL is not set, but the available project metadata tool did not expose the part-level Datasheet URL field for direct update.
  • Main issues flagged: MPN suffix discrepancy (DF10B+ vs datasheet ordering table DF11B+), missing pin descriptions/types, exposed pad connection needing confirmation, and footprint geometry needing numeric verification.
Suggested next steps:
  1. Set the part Datasheet URL field manually to the official EM Microelectronic PDF above.
  2. Confirm the DF10B+ vs DF11B+ suffix with EM Microelectronic/Digi-Key.
  3. Add datasheet-based pin descriptions and pin types to all terminals.
  4. Verify footprint pad geometry against the DFN10 3×3 drawing.
A

adrian95

Fix the pin descriptions/types, investigate the EP connection, and run a part review check afterward.

flux

I’ll update the terminal pin descriptions/types from the EM8900 datasheet, verify the exposed-pad recommendation, then run a review check and report any remaining issues.

flux

Updated all terminal pin descriptions and standardized pin types: AC/FB/LX*/DIS as Input, AVSS* as Ground, VSUP as Power Out, and EP as Passive.
Open items:
  • EP investigation: the official datasheet shows the DFN center pad mechanically but gives no explicit electrical connection instruction, so I documented EP as an exposed center pad with no specified connection.
  • Part review check returned no matching part-review findings/check items after the update, so there were no reported remaining part-review errors to address.
Suggested next steps:
  1. Confirm EP handling with EM Microelectronic if your footprint/library policy requires tying exposed pads to ground.
  2. Verify the footprint pad geometry numerically against the DFN10 3×3 drawing.
  3. Re-publish or release the part once the MPN suffix discrepancy is resolved.
Verify, document, export
Check footprint geometry
Update review document
Run full review
Export part report
Sign up to send

Files

Pins

Symbol

Layout

3D View

Name
Pin #
Type
Part Type
Pin Description
Terminal Order
AC
1
Input
Terminal
Rectifier input
FB
2
Input
Terminal
DCDC switching control
LX2
3
Input
Terminal
Transformer primary side connection
LX1
4
Input
Terminal
Transformer primary side connection
LX0
5
Input
Terminal
Transformer primary side connection
AVSS0
6
Ground
Terminal
Device ground connection
AVSS1
7
Ground
Terminal
Device ground connection
AVSS2
8
Ground
Terminal
Device ground connection
DIS
9
Input
Terminal
DCDC boost converter disable control; disabled when set to logic 1
VSUP
10
Power Out
Terminal
Supply output; externally limited/regulated, max operating 4.2 V
EP
11
Passive
Terminal
Exposed center pad shown in DFN10 mechanical drawing; datasheet gives no explicit electrical connection instruction

EM8900-V001-DF10B+