Part Datasheet Audit
Worked for 6 mins 8 sec
Grouped and verified all 39 pins with no duplicates:
- Power: 9 pins
- Ground: 6 pins
- GPIO: 19 pins
- Control: 2 pins
- Clock: 2 pins
- RF: 1 pin
Each pin’s Section matches its Pin Group. Power is oriented top, Ground bottom, GPIO left, and Control/Clock/RF right; pin names and ball numbers remain unchanged.
-
Make the functional group more general.
-
Add a Section property to all pins, and apply the same value used in the Pin Group property to each pin's Section property.
Assign a Terminal Order from 1 to 10, starting with Power. Power should be Terminal Order 1, and Ground should be last, Terminal Order 10. For Orientation, set Power to "Top" and Ground to "Bottom." For the remaining sections/groups, you may decide the Terminal Order and Orientation yourself. For Orientation, distribute them between "Left" and "Right" — don't put everything on one side. Each group/section should have a different orientation.
Thought for 19 sec
I’ll generalize the remaining signal groups, keep Section identical to Pin Group on every pin, and redistribute the non-power groups across left and right while preserving Power=1/Top and Ground=10/Bottom.
Worked for 1 min 14 sec
Updated and verified all pins:
- Power — Order 1, Top
- Control — Order 3, Right
- Digital I/O — Order 5, Left
- Clock — Order 7, Left
- Analog / RF — Order 8, Right
- Ground — Order 10, Bottom
Every pin now has a Section matching its Pin Group, with non-power groups distributed across both left and right sides. Pin assignments remain exclusive.
Fix metadata and verify
Use known group values
Add pin descriptions
Review symbol layout
Check footprint details
