Part Data Review and Verification
Thought for 21 sec
I found an existing Datasheet URL on the part, so I’ll use it for the cross-check rather than replacing it.
Worked for 1 min 5 sec
Reviewed the Abracon AMPLA1707Q-2R2MT part information and cross-checked it against the attached datasheet.
Key specs confirmed:
- Type: Shielded/molded power inductor, lead-frame/SMD construction
- Inductance: 2.2 µH ±20%
- DCR: 2.4 mΩ typ, 2.7 mΩ max
- IRMS: 43.5 A
- ISAT: 62 A
- Operating temp: -55°C to +125°C
- Package/body: ~17.6 × 16.9 × 6.7 mm
- Terminals: 2, non-polarized
Findings:
- Datasheet URL: already set, so I did not replace it.
- Symbol: matches a 2-terminal non-polarized inductor in intent.
- Footprint: pad count and land pattern appear consistent with the datasheet’s 2-terminal SMD landing pattern.
- Mismatch flagged: project property Mount = Wire appears incorrect; datasheet/footprint indicate SMD / lead-frame construction.
- Minor metadata gap: terminal pin descriptions are unspecified; datasheet treats the two terminals as equivalent, so this is not electrically risky but could be cleaned up.
Fix metadata and review
Fix part metadata
Run part review
Verify footprint dimensions
Update package metadata
To get started, talk to Flux or create a New Document.
