Part Review and Datasheet Update
Thought for 7 sec
I’ll update the package/description metadata and pin properties from the datasheet, then run a design review to catch any remaining symbol/footprint issues.
Thought for 47 sec
The project-level package is already set to 56-VQFN (7x7), so I’m updating the part description and terminal metadata now.
Worked for 2 mins 5 sec
Pin metadata is updated; I’m running the part/component review checks now.
Worked for 46 sec
Updated the part description and added datasheet-based Pin Type / Pin Description metadata for all 57 terminals, including supplies, grounds, analog inputs, references, digital interface pins, control pins, bypass nodes, and exposed pad.
Open items:
- None from the requested review scope; component review checks returned no ERROR/WARNING/OPEN/UNCERTAIN items.
- Package was already correct as
56-VQFN (7x7), so no package change was needed.
Suggested next steps:
- Publish the updated part if it’s ready for reuse.
- Optionally run a footprint geometry review against the TI land pattern before release.
Review and publish
Review footprint geometry
Publish updated part
Export part report
Check symbol grouping
