Created the requested terminal-order tables in ABX00087 Terminal Order Table (abx00087-terminal-order-table).

Short check: most terminals are OK; D0/TX0 should be renamed to D0/RX0 based on the datasheet. VBATT/VRTC is acceptable, though strict datasheet naming would be VRTC.

I’ll re-read the instruction file, compare it against the current terminal properties, then apply any missing Section / Terminal Order updates and verify.

Applied the requested Section, Terminal Order, and concise pin-description properties to all 35 terminals; I’m verifying the updates now.

Applied the file’s instructions to all 35 terminals: Power = order 1, Control = 2, Analog = 3, Digital = 4, Ground = 5, with Pin Group removed and GND pins set to Section = Ground.

Verified the updates. Rename still flagged: D0/TX0 should be D0/RX0 per the datasheet; I left the terminal name unchanged and noted the rename in its Pin Description.