Part Datasheet Audit

A

adrian95

Review all available part information (MPN, package, pin count, description, properties). If no datasheet URL is already set, search the web for the official datasheet and update the part's Datasheet property with the URL. Then cross-check the schematic symbol, footprint, and pin descriptions against the datasheet. Summarize key specs and flag any mismatches.

flux

I’ll audit the part metadata, locate the official datasheet if needed, update its Datasheet property, then verify the symbol, footprint, and pin descriptions against the manufacturer documentation.

flux

The official Honeywell datasheet is now linked, and the symbol/footprint audit found a pinout error plus undersized drill holes; both were corrected. I’m doing a final read-back against the datasheet before closing the review.

flux

Audit complete against Honeywell datasheet 32350268. The official datasheet URL is set; the I²C pinout and descriptions were corrected, and the six DIP drill holes were overridden from 0.7366 mm to the specified 1.0 mm.
  • Key specs: 0–1 psi gauge, 1.8–3.6 V digital supply, 14-bit pressure resolution, I²C address 0x28, 100–400 kHz.
  • Verified footprint: 6 pins, 2.54 mm pitch, approximately 11.0 mm row spacing, correct 1-2-3 / 6-5-4 ordering and pin-1 marker.
  • Open mismatch: published package metadata still reports 14-DIP instead of 6-PDIP. The correction did not persist after republishing, and an internal persistence issue was filed.
  • Copper pad diameter and exact 3D axial-port fidelity could not be conclusively validated because the datasheet only specifies the PCB hole diameter.
Fix metadata and review
Fix package metadata
Run ERC/DRC
Check BOM fields
Export part report
Sign up to send

Files

Pins

Symbol

Layout

3D View

Name
Pin #
Type
Section
Pin Group
Orientation
Order
Sub-symbol
Pin Description
GND
1
Ground
Ground reference voltage signal
VDD
2
Power In
Positive supply voltage
EOC
3
Output
End-of-conversion indicator; high when measurement and calculation are complete and data is ready to be clocked out
NC
4
Not Connected
No connection
SDA
5
Bi-Directional
I2C data input/output
SCL
6
Input
I2C clock input

ABP2DANT001PG2A3XX