Datasheet Verification
Worked for 5 mins 13 sec
Reviewed the part against the official Würth Elektronik source and updated the part’s Datasheet URL to the official WE-LQS page. The exact value-specific datasheet found is:
Key specs confirmed
https://www.we-online.com/components/products/datasheet/74404064101.pdf.- MPN: 74404064101
- Manufacturer: Würth Elektronik
- Series/package: WE-LQS, size/type 6045
- Part type: Semi-shielded SMT power inductor
- Inductance: 100 µH ±20%
- Rated current: 1 A max, ΔT = 40 K
- Saturation current: 1.2 A typ, |ΔL/L| < 30%
- DCR: 433 mΩ ±30% at 20 °C
- SRF: 6.3 MHz typ
- Operating voltage: 120 VDC max
- Operating temperature: −40 °C to +125 °C
- Qualification: AEC-Q200 Grade 1
- MSL: 1
- Body size: 6.0 × 6.0 × 4.5 mm max height
- Schematic symbol: Correct for a 2-terminal passive inductor.
- Pin/terminal count: Correct — datasheet shows a 2-terminal inductor.
- Pin descriptions: Electrically acceptable as passive terminals, but the datasheet marks the start of winding with a dot; the schematic terminals do not explicitly describe start/end of winding.
- Footprint: Matches the datasheet land pattern in the important dimensions: two rectangular SMT pads, approx. 1.8 mm × 5.7 mm, with 2.8 mm pad gap / 4.6 mm pad center spacing.
- Mismatch flagged: The footprint includes a pin-1/start-winding silkscreen dot, but the schematic terminal mapping is effectively reversed visually: schematic pin 1 is on the left, while footprint pad 1 is at positive X/right in the KiCad footprint. Electrically this usually does not matter for an inductor, but it is worth aligning if the start-of-winding mark is intended to be meaningful.
Fix mapping and audit
Fix winding marker
Set exact datasheet
Update part metadata
Run review checks
