Part Datasheet Audit


Review all available part information (MPN, package, pin count, description, properties). If no datasheet URL is already set, search the web for the official datasheet and update the part's Datasheet property with the URL. Then cross-check the schematic symbol, footprint, and pin descriptions against the datasheet. Summarize key specs and flag any mismatches.
I’ll audit the part metadata, locate the official datasheet if needed, verify symbol/footprint/pin mapping, and update the Datasheet property before reporting any mismatches.
Audit complete. The official Molex datasheet URL was already correctly populated, so no property update was necessary.
  • Part: Molex 2082940020, active Pico‑EZmate HC vertical SMT header
  • Configuration: 2 circuits, single row, 1.80 mm pitch, plus 2 mechanical retention nails
  • Ratings: 5 A/contact, 250 V AC/DC, −40 to +105 °C, 30 mating cycles
  • Construction: Gold-plated brass contacts, black PA housing, UL94 V‑0
  • Footprint: Signal-pad sizes/pitch and mounting-pad sizes match the recommended land pattern. However, the measured terminal-to-mounting-pad row spacing is 4.225 mm, while OCR extraction of the Molex drawing indicates 4.10 mm; this should be visually confirmed against the dimension arrows before production.
  • Symbol: Four terminals correctly correspond to circuits 1/2 and mounting nails MP1/MP2, but all pin types and descriptions are unspecified. MP1/MP2 should be identified as mechanical retention nails rather than ordinary electrical contacts.
  • Metadata: MPN, manufacturer, description, part type, designator prefix, lifecycle, circuit count, and mounting style are consistent. “Mount: PCB” is valid but less precise than “Surface Mount.”
Correct and verify part
Fix terminal metadata
Review footprint geometry

Name
Pin #
Type
Section
Pin Group
Orientation
Order
Sub-symbol
1
1
Unspecified
Left
2
2
Unspecified
Left
MP1
MP1
Unspecified
Bottom
MP2
MP2
Unspecified
Bottom

2082940020