• Official Molex sales drawing / datasheet:
• Molex product page:
• Existing Flux project metadata and footprint/schematic readback.

• Pin Type: Unspecified
• No Pin Description
• No explicit grouping of RF signal versus shield/body/ground legs

• Mismatch / incomplete: all five terminals are Unspecified; pin 1 should be identified as the center RF signal contact and pins 2-5 should be identified as shield/body/ground legs.
• Mismatch / incomplete: no Pin Description properties are populated.
• Usability issue: the symbol does not communicate coax connector semantics; it appears as five generic terminals rather than one RF center conductor plus shield/body connections.
• Usability issue: pins 2-5 are not documented as electrically common through the connector body/shield.

Text
pad 1: thru-hole circle at (0, 0), size 1.8 mm, drill 1.2 mm
pad 2: thru-hole circle at (-2.54, -2.54), size 1.8 mm, drill 1.2 mm
pad 3: thru-hole circle at (-2.54, +2.54), size 1.8 mm, drill 1.2 mm
pad 4: thru-hole circle at (+2.54, +2.54), size 1.8 mm, drill 1.2 mm
pad 5: thru-hole circle at (+2.54, -2.54), size 1.8 mm, drill 1.2 mm
fab outline: 6.36 mm square

• Recommended PCB mounting holes: 5 places
• Hole diameter: Ø1.20 mm REF
• Pattern: center hole plus four surrounding holes on a 2.54 mm grid, equivalent to a 5.08 mm × 5.08 mm square around the center
• Body / footprint reference: 6.36 mm square

• Matches: pin count, center + four-corner cross pattern, 2.54 mm grid spacing, 1.20 mm drill, and 6.36 mm body/fab outline align with the Molex drawing.
• Not a mismatch, but note: the 1.8 mm copper pad diameter is a land-pattern design choice; the extracted Molex drawing confirms the 1.20 mm hole but does not explicitly specify copper pad diameter. 1.8 mm gives a plausible 0.30 mm annular ring.
• No mechanical blocker found: basic through-hole footprint geometry is consistent with the official drawing.

1. Mount property mismatch: current Mount = Axial; datasheet says Through Hole PCB mounting.
2. Missing pin descriptions: add center contact / shield-body descriptions for pins 1-5.
3. Pin Type all Unspecified: change pin 1 and pins 2-5 to an appropriate passive connector/RF signal and shield/ground semantic.
4. Symbol semantics incomplete: symbol should distinguish RF center conductor from shield/body pins.
5. Frequency rating source conflict: legacy datasheet extraction reports 4 GHz, while the current Molex product page reports 6 GHz; document source attribution or confirm with Molex before using the higher value.

• Set Mount to Through Hole if the property schema allows it.
• Add terminal descriptions:
  • Pin 1: Center contact / RF signal
  • Pins 2-5: Shield / body / ground leg
• Set pin types to passive-style connector semantics rather than Unspecified.
• Optionally revise the schematic symbol so the center contact and shield pins are visually distinct.