Part Datasheet Audit and Updates
Worked for 8 mins 56 sec
Implemented the approved changes and updated Part Datasheet Audit.
Open items:
- ERC delta: 576 → 551 after Batch A support passives, then 551 → 496 after Batch B.
- Spot-checks: LT8610AB RT = 41.2 kΩ → ~1.002 MHz; TPS54540 FB = 1.05 MΩ / 200 kΩ → 5.000 V; TPS259827 RILIM = 211 Ω → ~7.03 A.
- U18/U12/U14/U16/U17 support passives are not wired yet because those refs still need exact/package-correct usable parts.
Suggested next steps:
- Proceed to Batch C: SDMMC1 → eMMC.
- Import/create exact missing power parts.
- Clean up tool-created net portal clutter later.
Thought for 1 min 8 sec
I read the attachment and extracted the new instructions: change TPS54540 FB divider to 10.5 kΩ / 2.00 kΩ, change TPS259827 RILIM to 210 Ω → ~7.06 A, create/import the missing power parts, wire their support passives, and proceed with Batch C eMMC wiring.
Open items:
- I’m blocked now because there are no available ACUs.
- The value table has not yet been updated with the new corrections.
- Missing parts still need create/import: U18, U12, U14, U16, U17.
- Batch C SDMMC1→eMMC has not been wired yet.
- ERC delta after Batch C still needs to be run.
Suggested next steps when ACUs are available:
- Update the support table corrections.
- Create/import missing power parts with “generated — verify pin map against DS” flags.
- Wire support passives and Batch C.
- Run ERC and report the delta.
Create missing parts
Update value table
Wire Batch C
Run ERC delta
