Welcome to your new project. Imagine what you can build here.

Here is a simple USB powered lamp that can be used to light your desktop during power failures. The circuit operates from the 5 Volt available from the USB port. The 5V from the USB port is passed through current limiting resistor R2 and transistor Q1. The base of transistor Q1 is grounded via R1 which provides a constant bias voltage for Q1 together with D2. The diode D1 prevents the reverse flow of current from battery. C1 is used as a noise filter. Two white LED’s are used here for the lamp, you can also use a 2 V torch bulb instead of LED’s. LED D3 indicates connection with USB port.

Here is a simple USB powered lamp that can be used to light your desktop during power failures. The circuit operates from the 5 Volt available from the USB port. The 5V from the USB port is passed through current limiting resistor R2 and transistor Q1. The base of transistor Q1 is grounded via R1 which provides a constant bias voltage for Q1 together with D2. The diode D1 prevents the reverse flow of current from battery. C1 is used as a noise filter. Two white LED’s are used here for the lamp, you can also use a 2 V torch bulb instead of LED’s. LED D3 indicates connection with USB port.

Electric lamp. See https://en.wikipedia.org/wiki/Electric_light

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Sensor using through hole LDR and power with SMT LED Resistors and PZT3904

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Smart Lamp System: Compact ESP32-Based Sensor-Integrated LED Lighting Solution

Light Detection: The LDR detects the ambient light level. When it is dark, the resistance of the LDR is high, resulting in a higher voltage at the inverting input (pin 2) of the op-amp. Comparison: The op-amp compares the voltage at pin 2 with the reference voltage set at pin 3 by the potentiometer (R3). If the voltage at pin 2 is higher than the reference voltage at pin 3 (indicating darkness), the op-amp output goes high. Transistor Activation: The high output from the op-amp turns on the transistor (Q1) by providing base current through R4. Relay Activation: When Q1 is turned on, current flows through the relay coil, energizing it and closing the relay contacts. Lamp Operation: The closed relay contacts complete the AC circuit, allowing current to flow and turning on the lamp (LA1). Light Detection (Daytime): When it is light, the resistance of the LDR decreases, resulting in a lower voltage at pin 2 of the op-amp. If this voltage is lower than the reference voltage at pin 3, the op-amp output goes low, turning off Q1, de-energizing the relay, and turning off the lampWelcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

6S Li-ion USB-C charged 40V/0.75A PWM-dim LED driver with 433MHz remote

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

como hacer una lampara led con un panel solar y un bms para la carga de una bateria para el uso independite del panel solar lo mas faci posible

lampara sanabius cargaada con un generador