Arduino Digital IR Sensor Integration with Schmitt-Trigger Conditioning

A simple audio amplifier shield for the Arduino Uno R3. All through-hole components. #shield #arduino #lm386 ## Usage The output connector is male molex (shrouded), good for cheap laptop speakers like this one: aliexpress.com/item/1005006144805292.html Don't use a speaker under 4ohms. Make sure the arduino is given 5V input. The volume is controlled by a 10k pot.

Arduino UNO Rev3 Microcontroller Board, ATmega328P Ћ Arduino A000066

XBOX Controller Based on ATmega32U4 Arduino Micro AVR® ATmega AVR MCU 8-Bit Embedded Evaluation Board #project-template #template #arduino #micro

Arduino Uno shield used to monitor chimney smoke and provide feedback to stove. This shield powers the Arduino using TEGs and a battery. This shield provides power to an LED, fans, and a light sensor used to detect light intensity.

Template for Arduino Uno R3 Shield. Include an official pinout so you will always know Arduino names, the alternative roles of pins, which one is SDA, or SCL, etc. On PCB you can find the 3D model of the Arduino Uno R3 itself along with the board outline on the silkscreen. #Arduino #Uno #Shield #Template #project-template #project

The Micro is a microcontroller board based on the ATmega32U4 (datasheet), developed in conjunction with Adafruit. It has 20 digital input/output pins (of which 7 can be used as PWM outputs and 12 as analog inputs), a 16 MHz crystal oscillator, a micro USB connection, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a micro USB cable to get started. It has a form factor that enables it to be easily placed on a breadboard. The Micro board is similar to the Arduino Leonardo in that the ATmega32U4 has built-in USB communication, eliminating the need for a secondary processor. This allows the Micro to appear to a connected computer as a mouse and keyboard, in addition to a virtual (CDC) serial / COM port.

This is a controller for micro drone made using Arduino Nano and NRF24L01 module. *Left Joystick* X : Throttle Y : Yaw *Right Joystick* X : Roll Y : Pitch Input Voltage : Greater than 5V Connect NRF24L01 (with adapter module) using jumper wires

Micro PLC based on RP2040 and programmable via Arduino IDE

XIAO SAMD21 powered by Microchip SAMD21G18 chip is an ultra-small, high-performance universal development board, the pioneering product of the XIAO series. It supports Arduino / Micropython / CircuitPython development, which is the perfect microcontroller for you to get started with electronics.

Arduino Nicla Voice Integration with HDMI Output for Edge AI