High-Voltage Piezo Amplifier Design
Worked for 22 mins 13 sec
Thought for 8 sec
Reading project docs.
Thought for 19 sec
Updating 2 project docs.
Thought for 6 sec
2/3 Build the supported amplifier, power-supply, filtering, and protection schematic.
Set provisional noise targets and independently check the regenerative amplifier architecture.
Build the supported amplifier, power-supply, filtering, and protection schematic.
Verify connectivity, ratings, and simulations; document any remaining blockers.
Thought for 32 sec
Awaiting 1 task
"Provisional Piezo Driver Schematic" completed.
Thought for 6 sec
I recorded provisional prototype targets of 5 mV RMS output noise, 20 mV peak-to-peak switching ripple, and 0.1% THD in the Specification. These are design goals—not achieved results or guaranteed microscope resolution.
I checked the regenerative architecture and started schematic capture. Your project now contains 28 components and 18 nets, including an auxiliary regulator and passive circuitry, but it is not yet a complete or verified high-voltage piezo driver.
Remaining work includes:
- Completing the regenerative power stage, bus supply, filtering, and control loop.
- Verifying current limits, returned-energy handling, temperature shutdown, and safe discharge.
- Checking connectivity and simulating stability, ripple, and continuous-operation losses before layout or hardware testing.
Do not connect the actuator or apply high voltage to this unfinished design. Execution stopped because your ACUs ran out.
Waiting for input
